ACM12 - module for creating ACCESS point

Access module, connected to the BUS bus of DIGIPLEX EVO control panels. It is used to create 1 access point - 1 reader, 2 detectors (magnet, PIR detector) for monitoring passages through the door, relay output to open the door lock, power supply. The module supports the connection of readers with Wiegand 26 bit output and readers with RS485 PARADOX output.

For readers from other manufacturers, do not switch on the audible signal, if the buzzer is activated, the reader will stop reading the enclosed cards.

ATTENTION! Versions 4.50 and higher are no longer compatible with older versions of control panels, connect only to control panels v4.50 and higher. To complete older installations, purchase ACM v4.13 (1509-007)

Module type	access module + source
Programming software	BABYWARE
Addressing of the module in the system	unique SN number
Reader input	yes, 1 indoor / outdoor RS485 / Wiegand 26 bit reader
Interface for readers from other manufacturers	Wiegand 26 bit
Power supply	16 V ~, 40 VA
Power supply	one transformer. for multiple modules
Source type	switched
Max. current consumption from AUX output	1A
AUX output type	electronic return fuse 1.1 A
Recommended backup battery	12 V, 7 Ah / 18 Ah
Current consumption of the module	max.80 mA
Number of entrances / zones	2, CT zone (magnet), REX (detector)
Tamper entrance	yes, NC tamper module
Programmable PGM output	yes, 1 x transistor 50 mA
Output for opening the door lock	yes, 1 x relay
Max. output load	5 A / 25 V =, NC / NO
Optical signaling	BUS RX / TX / ERROR LED
Optical signaling	AC / BATT / AUX LED
Recommended transformer type	40 VA, separate transformer
Recommended type of box	BOX M-40, BOX S-40, BOX VZ-40